GREAT PLANES Kunai Manuale di istruzioni - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni per Giocattolo GREAT PLANES Kunai. GREAT PLANES Kunai 17. Model aircraft great planes kunai

Install the Motor and ESC

Do not mount the propeller until instructed to do so.

❏

1. Cut off the three motor wires 1/4" [6mm] from the end

of the ESC.

❏

2. Strip, twist, then tin the exposed wire as shown in the

image (for illustration purposes the middle wire has been

stripped and twisted and the top wire has been tinned in

preparation for re-soldering on the bullets).

❏

3. Unsolder the bullet connectors from the cut off wires

and solder them back onto the ESC. The best way is to heat

the bullet, then insert the wire into the molten solder in the

bullet and allow it to harden.

❏

4. Insulate the bullet connectors with 3/16" [5mm] shrink

tubing, then connect the ESC to the motor so the motor will

turn the correct direction (this will require temporary connection

of the receiver and a battery). Guide the lead wire from the

ESC down under the servo tray. Then, use thin, double-sided

foam tape to mount the ESC to the fuselage side. NOTE: Be

certain the motor wires do not rub against the motor.

❏

5. Attach an approximately 2-1/2" [60mm] strip of the

rougher, "hook" side of the included adhesive-back hook-

and-loop material to the bottom of the fuselage as shown.

For added security, apply a few drops of thin CA around the

edges of the strip to glue it down to the fuselage.

Install the Servos and Receiver

Refer to this photo while performing ﬁ nal radio installation.

❏

1. Place the elevator and rudder servos in the servo tray,

but do not screw them down yet.