GREAT PLANES Slinger GPMA1180 Manuale di istruzioni - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per Giocattolo GREAT PLANES Slinger GPMA1180. GREAT PLANES Slinger GPMA1180 12. Speed 400 electric fun fly arf
Stampa la pagina
Install the Center Section
1. Remove the pushrods from the control horns. Insert
the pushrods through the holes in the center section. Route
the servo wires through their respective holes. Position the
center section onto the wing and check that the hole for the
receiver antenna is aligned with the antenna tube in the left
wing panel. Adjust the hole in the center section as needed.
2. Attach the center section to the wing with clear tape.
Tape all of the edges securely.
Caution: The center section must be securely taped to the
center section. It contains the heavy battery and motor. The
center section also generates considerable lift in flight.
3. Plug the ailevator servos into the optional mixer
(if used) as shown in the photo. Note the aileron and
elevator plugs that go to the receiver. You may need to
reverse the plugs to the receiver if the ailevators do not
respond correctly. The elevator stick should move both
ailevators in the same direction while the aileron stick
should move them in opposite directions.
4. Plug the motor wires into the ESC and plug the ESC
into the receiver. Plug the servos into the proper receiver
channel (or mixer if used). Insert the receiver antenna into
the antenna tube in the top of the left wing panel until it
comes out the other end. In the above photo the mixer is
held to the receiver with double-sided foam tape. The
receiver is held in the receiver compartment, also with
double-sided tape. The ESC will go on the top of the battery
after it is placed in the battery compartment.
Install the Wing Tips
1. Apply the decals onto the wing tips as shown in the photo.
Position the wing tip onto the wing panel and mark the tip where
it meets the wing. Cut and remove the decal from the wing tip
about 1/16" [1.6mm] inside the marks you made. Roughen the
exposed surface with sandpaper. Warning: The wing tip is
glued to the wing. Failure to remove the decal material from the
mating surface of the tip may allow the tip to separate in flight.
Note: The wing tips should extend below the bottom of the wing
enough so that the ailevators do not snag on the tips when the
ailevators are down. See the photo that follows.
2. Glue the wing tips to the wing with 6-minute epoxy.
7