GREAT PLANES Slinger GPMA1180 사용 설명서 - 페이지 7

{카테고리_이름} GREAT PLANES Slinger GPMA1180에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Slinger GPMA1180 12 페이지. Speed 400 electric fun fly arf

Install the Center Section

1. Remove the pushrods from the control horns. Insert

the pushrods through the holes in the center section. Route

the servo wires through their respective holes. Position the

center section onto the wing and check that the hole for the

receiver antenna is aligned with the antenna tube in the left

wing panel. Adjust the hole in the center section as needed.

2. Attach the center section to the wing with clear tape.

Tape all of the edges securely.

Caution: The center section must be securely taped to the

center section. It contains the heavy battery and motor. The

center section also generates considerable lift in flight.

3. Plug the ailevator servos into the optional mixer

(if used) as shown in the photo. Note the aileron and

elevator plugs that go to the receiver. You may need to

reverse the plugs to the receiver if the ailevators do not

respond correctly. The elevator stick should move both

ailevators in the same direction while the aileron stick

should move them in opposite directions.

4. Plug the motor wires into the ESC and plug the ESC

into the receiver. Plug the servos into the proper receiver

channel (or mixer if used). Insert the receiver antenna into

the antenna tube in the top of the left wing panel until it

comes out the other end. In the above photo the mixer is

held to the receiver with double-sided foam tape. The

receiver is held in the receiver compartment, also with

double-sided tape. The ESC will go on the top of the battery

after it is placed in the battery compartment.

1. Apply the decals onto the wing tips as shown in the photo.

Position the wing tip onto the wing panel and mark the tip where

it meets the wing. Cut and remove the decal from the wing tip

about 1/16" [1.6mm] inside the marks you made. Roughen the

exposed surface with sandpaper. Warning: The wing tip is

glued to the wing. Failure to remove the decal material from the

mating surface of the tip may allow the tip to separate in flight.

Note: The wing tips should extend below the bottom of the wing

enough so that the ailevators do not snag on the tips when the

ailevators are down. See the photo that follows.

2. Glue the wing tips to the wing with 6-minute epoxy.