GREAT PLANES MASTER CADDY Manuale di istruzioni per il montaggio - Pagina 10
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Strumenti di misura GREAT PLANES MASTER CADDY. GREAT PLANES MASTER CADDY 15. With auxiliary power station
Stampa la pagina
five blocks that are glued to the uprights should be
lined up with edge of the uprights, but the block that
is glued to the front should be spaced in far enough to
allow for the thickness of the APS side (approx. 1/8").
O
10. Glue the APS side B in place. The top edge
should line up with the top of the front and the side should
be pressed up tight against the front. Do not worry about
lining up the other edges. You will sand those later to fit
the caddy.
(J 11. Mark the locations of the basswood blocks on
APS side A by using arulerand measuring from different
sides to figure out where the blocks are. Hold or tape
APS side A in position and drill eight 5/64" holes
through the side and into the basswood blocks. Remove
the APS side and enlarge the holes you just drilled in the
APS side to 1/8" diameter. Attach the side with eight #4
x 3/8" sheet metal screws.
g
O
12. Trial fit the APS onto the MASTER CADDY.
You may have to sand the back edges of the APS Sides
so they will match the sides of the caddy. You should
tighten or loosen the two retaining screws until the APS
slides on and off easily but is still held firmly in place.
10
The APS should actually rest on the bottom of the caddy
(all the screws do is hold the APS against the caddy
upright). You may also have to sand the bottom edges of
the APS to make them match up with the bottom edges
of the caddy sides.
CO 13. When satisfied with the fit of the APS, put a
couple drops of thin C/A around each retaining screw.
This will help toughen up the wood in this area and keep
the screws from working loose.
DRAWER ASSEMBLY
C
1. Glue one of the drawer backs to the long edge
of one of the drawer bottoms. Use one of the drawer
sides to keep the drawer back perpendicular to the
drawer bottom.