GREAT PLANES MASTER CADDY Manuale di istruzioni per il montaggio - Pagina 11
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Strumenti di misura GREAT PLANES MASTER CADDY. GREAT PLANES MASTER CADDY 15. With auxiliary power station
Stampa la pagina
(J 2. Glueoneofthe drawer sidesin place against the
side edges of the drawer back and the drawer bottom.
Glue the other drawer side in place
CO 3. Glue the two drawer dividers in place. These
dividers can be positioned anywhere and in any drawer
you prefer. We put both of the dividers in one drawer so
we can carry large props in the other drawer.
NOTE-
do not add the drawer fronts yet!
(J 4. Assemble the other drawer in the same sequence
that you just assembled the first drawer.
O 5.
Break offacouple scrap pieces of 1/8" plywood
from the die cut cradle sheet similar to those in the photo.
(0 6. Usethe 1/8" plywood scraps to center the drawer
in its space and push the drawer in so that it only sticks
out about 1/8". Ifthe 1/8" shims are too thick you canuse
some cardboard or similar type material for this purpose.
( 7. Apply acouple of drops
of thick C/A
on the front
ends of each drawer side and immediately push the
drawer in slightly with the drawer front. At the same
time position the drawer front so it is properly posi-
tioned in relation to the caddy. Spray some C/A accel-
erator inside the drawer to cure the glue and then very
carefully remove the drawer from the caddy.
8. Check the alignment of the drawer front with
the rest of the drawer and if satisfied, apply a generous
bead of glue around the inside joints.
9. Punch outthe three cradle pieces from one of the
die cut cradle sheet and lay the remaining ''skeleton'' in
the bottom of the drawer space. This will be used to
properly position the top drawer.