GREAT PLANES MASTER CADDY Manuale di istruzioni per il montaggio - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Strumenti di misura GREAT PLANES MASTER CADDY. GREAT PLANES MASTER CADDY 15. With auxiliary power station
Stampa la pagina
CO 15. Remove the APS bottom and apply a bead of
glue around the shelf to securely glue it in place.
E
;
C
16. The compartment which will hold your trans-
mitter should be laid out now. Itis best to put it on the
same side of the MASTER CADDY as the drawers so
you won't hit the transmitter sticks on your leg when you
carry it. Use shelf divider A as a spacer and draw a line
down the long edge of the divider. Remove the divider
and test fit your transmitter in place to make sure it fits.
This method makes
a compartment
approximately
2-5/8" wide which will hold most transmitters. You can
put this divider any distance you wish from the side.
O
17. Use the divider again to mark a vertical line on
one of the uprights (it does not matter which one). It just
depends on where you would like the compartment to be,
We marked the upright closest to the fuel compartment,
C
18. Glue shelf divider A in place and then glue shelf
divider B in place against the end of divider A, With the
compartments laid out as shown, you will have a com-
partment for your transmitter, a compartment for glues
and small tools, and the remaining compartmentis large
enough for your voltmeter, field charger and all kinds of
larger support items that most field boxes would have to
leave behind.
C 19. Slide the wooden dowel handle through the
hole in one upright and into the hole in the other upright.
If the fit is too tight to slide the dowel through, sand the
hole to enlarge it slightly. Glue the dowel in place and
sand off any excess dowel flush with the uprights.