Automatic DB 5801 Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Automatic DB 5801. Automatic DB 5801 13. 250w multi tool

Stampa la pagina

Installing sanding pad and sandpaper

1. Install the hook &

loop sanding pad

onto the tool.

Notes:

a) The big washer is NOT

required to install the

sanding pad. Use the 2 x

washers as indicated on

Page 8 for the sanding

pad installation.

2. Firmly press the

sandpaper onto the

hook & loop pad.

Notes:

a) Place the sandpaper

so the holes in the

sandpaper line up with

the matching holes in the

hook & loop pad.

b) Press the sandpaper

firmly onto the hook &

loop pad.

3. To remove the sandpaper, simply peel the

sandpaper away

from the hook &

loop pad.

On/off switch

1. To turn the tool

ON, slide the ON/

OFF switch toward the front of the tool.

2. To turn the tool OFF, press the rear part of

the ON/OFF switch and allow the switch to

slide to off position.

Flush cutting a door jamb and casing

for installing flooring

The oscillating tool

can be used to flush

cut a door jamb and

casing to allow space

for the new flooring

to fit neatly under the

door jamb and casing.

For the purpose of

demonstrating the

procedure, floor tile is

being used.

1. Install the plunge cutting wood saw blade

for wood in the tool.

Note: The blade should be centred on the tool housing

and NOT installed in the 90° position.

2. Place a scrap piece of floor tile (1) on the

floor about 1/2" (12.5mm)from the door

jamb (2).

Note: Make sure the "good" side of the tile is facing

upward to provide a smooth surface for the blade to follow.

3. Place the tool with the saw blade (3) lightly

touching the surface of the tile and the

cutting teeth NOT touching the surface to

be cut.

4. Carefully plunge the blade into the door

jamb while sliding the blade along the