Automatic DB 5801 Manuale di istruzioni - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Automatic DB 5801. Automatic DB 5801 13. 250w multi tool

Stampa la pagina

floor tile.

Note: Hold the tool tightly and do not put too much

forward pressure on the saw blade when cutting, as this will

cause the tool to vibrate excessively.

5. Continue to make several plunge cuts until

the bottom of the door jamb and casing

are completely cut off and the loose

pieces can be easily removed.

Follow the same basic procedure for installing carpet, using

a thicker spacer that is the same thickness of the carpet

being installed.

Cutting a hole in wood flooring to

install a heating vent

The oscillating tool can be

used to cut a hole in wood

flooring for installing a

heating vent.

1. Install the plunge

cutting saw blade

for wood in the

tool.

Note: The blade should be

centred on the tool housing

and NOT installed in the 90°

position.

2. Place the floor vent on the floor and use

a soft lead pencil to trace the required

rectangular hole (1) on the flooring.

3. Place the saw blade (2) near the floor

surface in the middle of one of the cutting

lines.

4. Turn the tool ON.

Note: The tool and blade should be at a 45° angle to the

floor to allow the corner of the blade to plunge cut into the

flooring.

5. While holding the tool tightly, slowly

plunge the corner of the blade into the

flooring until it cuts through the flooring.

Once the plunge cut is complete, then

complete the cut to the corner of the

rectangle.

6. Turn the saw OFF, remove it from the

cut and proceed to cut in the opposite

direction to complete the cut for the first

side of the rectangle.

7. Repeat steps #4, #5 & #6 to cut the

remaining three sides of the rectangle.

8. When all cuts are complete, use a flat

blade screw driver to carefully pry the cut-

out from the floor.

Note: Do NOT use the saw blade to pry the cut-out from

the floor. You will break the blade. If the cut-out is not easy

to pry from the floor, check to make sure each line is cut

completely into the corner of the rectangle.

Using the sander attachment

1. Install the sanding pad on the multi tool as

outlined on page 10.

2. Install the sandpaper on the sanding pad.

3. Turn the switch ON.

This tool is designed for detail sanding on small surface

areas. Place the sandpaper surface of the sanding pad on

the workpiece to be sanded. Keep the tool moving to avoid

gouging the surface.