GREAT WATER M1D2 Manuale dell'installatore e dell'utente - Pagina 5

Sfoglia online o scarica il pdf Manuale dell'installatore e dell'utente per Distributore d'acqua GREAT WATER M1D2. GREAT WATER M1D2 8.

8. Setting The Controller

Turn on the power and the softener will display Welcome

The display will automatically alternate between Time and Hardness.

To commission the water softener you will need to set both Time (24hr Clock in hours and

minutes) and Hardness as determined above.

Wait until the display reads Time.

Press the up arrow and the display

Will change to Set Time : 8:00*

Using the up and down arrows set to

the current time of day (24 Hr Clock)

while the figures flash.

*if the time has advanced don't worry

Just programme as normal.

Power indicator light

Down Arrow Button

Regeneration button

Up Arrow button

Wait until the display changes to Hardness then press the up arrow and the display will change

to Set Hardn:10

Using the up and down arrows set the display to the number obtained in your hardness test.

That's it you've finished the programming. The display will now revert to the alternating display.

If at any time you need to re-programme or re-set any figure then just wait until the display

changes to the relevant setting and press the up arrow to get started.

9. Flush the Water Softener - IMPORTANT

Close the by-pass valve and open the inlet and outlet valves (fig 1) and Check for leaks.

Open a mains soft tap and allow this to run for at least 5 minutes. This will purge any air and

resin dust (which may appear brown or orange in colour) from the system.

Fill the softener with a good quality Tablet salt. To within 100mm of the top of the cabinet.

The water softener will not generally have water in the salt tank and is known as a dry salt

softener. When regenerating the softener will add water to the salt tank as required.

Part of this commissioning only, add 1 litre of water to the salt tank.

If at any time the softener has a significant amount of water in the salt tank and the softener is

not regenerating then please contact us for advice or a service visit.

Great Water: 01932 245783 [email protected]