Daza 8014 PRO Manuale d'uso
Sfoglia online o scarica il pdf Manuale d'uso per Unità di controllo Daza 8014 PRO. Daza 8014 PRO 2. Wireless table / wall button
Stampa la pagina8014 PRO
Wireless table / wall button
14-12-23 V1.3
General:
The wireless table/wall button alarms when someone closely approaches or presses the red button. The button can easily be
used on a table or mounted onto a wall. To ease finding the button at night, a light placed behind the red button will shortly
light up every 2 seconds. This option can be turned off. The 8014 Pro can be used in combination with DAZA receivers and
pagers.
Put into use:
The battery is already installed, however the button is still in sleep mode. By pressing the red button, the button will come out
of its sleep mode and will send an alarm. From now onwards, the orientation-lighting will be lightly visible every 2 seconds,
as well as the approaching function will be activated. With touch or approach of the red button (+/- 1cm), it will alarm. A beep
will sound and the lighting under the red button will light up brightly. The 8014 PRO will have to be read into a receiver.
Consult the manual of the receiver to see how to do this. If the button is delivered together with a receiver it is probably that
they have already been coupled.
Settings:
Multiple settings are available. To access these, the casing of the button will have to be opened.
The switches are very small. Use a needle for example to carefully move them.
Opening of the casing:
Remove the screw from the side of the casing.
Turn the lid until the mark and lift the lid.(figure 1)
Function settings:
The 8014 Pro has 8 dipswitches of which at the moment only the first 4 are being used
(see figure 2). These have the following function settings:
Switch
1 Approaching function
2 Orientation lighting
Switch 3 and 4 determine the volume of the beep.
High volume
3 ON
Medium volume
3 OFF
Low volume
3 ON
Buzzer off
3 OFF
*By default all switches are turned on (turned forward).
Approach Function:
When switch 6 is set to OFF (downward position), you have 5 seconds to cancel any accidentally activated alarm. If you
have chosen this option, the system will emit a sound signal 5 times during this period. If you approach the button again
within that time, the alarm will be canceled without sending a wireless signal. If the 5 seconds elapse without re-approaching
the button, the wireless alarm will be triggered. This option introduces a short delay before the alarm goes off.
DAZA Opticare B.V. follows a policy of constant improvements in the development of their products. The technical data can therefore be altered without preceding notification.
This product is classified as an electrical and electronic device. In case you wish to dispose of this product, please make sure this is done in accordance with the European guidelines regarding disposal of electrical and electronic
devices (AEEA) and conform the local legislation in regards to this guideline.
ON
OFF
ON
OFF
ON
OFF
4 ON
4 ON
4 OFF
4 OFF
User Manual
Figure 2: Battery placement and Dipswitches
Figure 1: Opening of button
P a g e
1
o f
2