Daza 8014 PRO Посібник користувача

Переглянути онлайн або завантажити pdf Посібник користувача для Блок управління Daza 8014 PRO. Daza 8014 PRO 2 сторінки. Wireless table / wall button

Друкувати сторінку

8014 PRO

Wireless table / wall button

14-12-23 V1.3

General:

The wireless table/wall button alarms when someone closely approaches or presses the red button. The button can easily be

used on a table or mounted onto a wall. To ease finding the button at night, a light placed behind the red button will shortly

light up every 2 seconds. This option can be turned off. The 8014 Pro can be used in combination with DAZA receivers and

pagers.

Put into use:

The battery is already installed, however the button is still in sleep mode. By pressing the red button, the button will come out

of its sleep mode and will send an alarm. From now onwards, the orientation-lighting will be lightly visible every 2 seconds,

as well as the approaching function will be activated. With touch or approach of the red button (+/- 1cm), it will alarm. A beep

will sound and the lighting under the red button will light up brightly. The 8014 PRO will have to be read into a receiver.

Consult the manual of the receiver to see how to do this. If the button is delivered together with a receiver it is probably that

they have already been coupled.

Settings:

Multiple settings are available. To access these, the casing of the button will have to be opened.

The switches are very small. Use a needle for example to carefully move them.

Opening of the casing:

Remove the screw from the side of the casing.

Turn the lid until the mark and lift the lid.(figure 1)

Function settings:

The 8014 Pro has 8 dipswitches of which at the moment only the first 4 are being used

(see figure 2). These have the following function settings:

Switch

1 Approaching function

2 Orientation lighting

Switch 3 and 4 determine the volume of the beep.

High volume

3 ON

Medium volume

3 OFF

Low volume

3 ON

Buzzer off

3 OFF

*By default all switches are turned on (turned forward).

Approach Function:

When switch 6 is set to OFF (downward position), you have 5 seconds to cancel any accidentally activated alarm. If you

have chosen this option, the system will emit a sound signal 5 times during this period. If you approach the button again

within that time, the alarm will be canceled without sending a wireless signal. If the 5 seconds elapse without re-approaching

the button, the wireless alarm will be triggered. This option introduces a short delay before the alarm goes off.

DAZA Opticare B.V. follows a policy of constant improvements in the development of their products. The technical data can therefore be altered without preceding notification.

This product is classified as an electrical and electronic device. In case you wish to dispose of this product, please make sure this is done in accordance with the European guidelines regarding disposal of electrical and electronic

devices (AEEA) and conform the local legislation in regards to this guideline.

OFF

4 ON

4 OFF

User Manual

Figure 2: Battery placement and Dipswitches

Figure 1: Opening of button

P a g e

o f