Activeforever KA1000 Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Sveglia Activeforever KA1000. Activeforever KA1000 17. Dual alarm clock with wireless alarm monitoring receiver

REGISTER TRANSMITTERS TO THE CLOCK

After installation, the KA1000 is ready to register its door knock, doorbell, telephone ring-
er, and other accessories in the system. The door knock, telephone ringer and baby room
call will be installed in channel 2 (C2). Other monitoring transmitter will be installed in
channel 1 (C1). The dip switch code of each transmitter will be stored in KA1000 channel
memory indicated by: CX:OX -> MEMORY LOCATION
Registering the door knock with the KA1000:
1. Insert a paper clip into reset hole two times, until the display reads "[C2:01]"
2. Turn on the door knock transmitter KA1000DK and push the test button. Release
the button when the display counter increases to "[C2:02]". If the display reads
"[C2:FU]" the memory is full, and a new device will not be accepted. If an other
transmitters need to be registered, repeat these steps.
3. After 10 seconds, and there is no more transmitters to be register, the clock will
return to normal time display mode.
FIG. 5.1
After the ID of the transmitter is recorded into the memory, the clock will trigger to the
signal sent from this transmitter and display the cause. You can register any transmitter at
any time repeating those steps. Record the description of that transmitter to page 19 of this
book for future reference.
Channel 1 or C1 is used for the Alarm Monitor sensors, do not use it for the door knock,
telephone ringer or Baby room call transmitter of channel 2 or [C2:xx]. Each memory has 3
entries for 3 different kind transmitters. If you have more than one transmitter of one kind,
for example you have 2 door knock transmitters, register for only one.

Change system security code

If your clock encounters interference and repeatedly activates it-
self for no obvious reason maybe there is a system nearby in your
neighborhood triggering the alarm. Change the channel switches
setting on all transmitters and repeat the above steps for the new
setting. (see Figure 6) If your memory is full, unplug the clock and
take the battery out for 5 seconds then repeat the setup procedure.
If the clock is going be used with the Alarm Monitor KA300, take
one transmitter and change to a new operation code then repeat the
setup procedure for both KA1000 and KA300 units.
(Fig 7.1, 7.2, 7.3)
LED Display
C1 : 01
Reset hole
C2 : 01
Paper clip
- 9 -
Insert the paper clip
to reset hole two
time. The display
will change memory
channel to Channel 2.
FIG. 6