Dynalite DBC410 Manuale di installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione per Controllore Dynalite DBC410. Dynalite DBC410 8. 4 x 10a hf ballast controller

AUX Input - This is a dry contact interface that is active low. The dry contact is connected between the AUX

and GND terminals on the DyNet connector strip. The function of the AUX input is programmable. Ensure

that the cable length between the dry contact and terminal strip is no longer than 2 metres.

Service LED - The Service LED has 3 signalling modes, which are useful for troubleshooting:

Blinking slowly (1Hz) = Normal Operation

Blinking fast (4Hz) = Network Activity Detected

On = Fault

Service Switch - The Service Switch has three functions:

1 push = Transmit Network ID

3 pushes = All Channels 100%

Push & hold for 4 sec = Reboot

Top Set - This adjusts the maximum output that all other control sources can select, ie: if the Top Set is fully

clockwise, 100% selected by a control source will give 100% output. If it is fully anti-clockwise, 100%

selected by a control source will give 50% output. This control is useful for extending lamp life and can be

operated without any form of network control, effectively turning the device into a stand-alone power

conditioner and lamp protector.

Accessory Module Socket - Accepts plug in modules for optional features such as DMX512 ports and Time

clocks. Consult your distributor for details on the available accessory modules.

DBC410 Installation Manual Rev K.docx