Dynalite DBC410 설치 매뉴얼 - 페이지 7
{카테고리_이름} Dynalite DBC410에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynalite DBC410 8 페이지. 4 x 10a hf ballast controller
페이지 인쇄AUX Input - This is a dry contact interface that is active low. The dry contact is connected between the AUX
and GND terminals on the DyNet connector strip. The function of the AUX input is programmable. Ensure
that the cable length between the dry contact and terminal strip is no longer than 2 metres.
Service LED - The Service LED has 3 signalling modes, which are useful for troubleshooting:
Blinking slowly (1Hz) = Normal Operation
Blinking fast (4Hz) = Network Activity Detected
On = Fault
Service Switch - The Service Switch has three functions:
1 push = Transmit Network ID
3 pushes = All Channels 100%
Push & hold for 4 sec = Reboot
Top Set - This adjusts the maximum output that all other control sources can select, ie: if the Top Set is fully
clockwise, 100% selected by a control source will give 100% output. If it is fully anti-clockwise, 100%
selected by a control source will give 50% output. This control is useful for extending lamp life and can be
operated without any form of network control, effectively turning the device into a stand-alone power
conditioner and lamp protector.
Accessory Module Socket - Accepts plug in modules for optional features such as DMX512 ports and Time
clocks. Consult your distributor for details on the available accessory modules.
7
DBC410 Installation Manual Rev K.docx