Gainsborough TRILOCK G1 Series Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Per serrature Gainsborough TRILOCK G1 Series. Gainsborough TRILOCK G1 Series 4. Eclipse dummy, suits 35mm to 45mm door thickness
Anche per Gainsborough TRILOCK G1 Series: Istruzioni per l'installazione (2 pagine)

Stampa la pagina

Installation Instructions for 8955 BB Series Omni Trilock

Twin Pull Handle Version - Suits 35mm to 45mm door thickness

Step 5

• Remove perforated cut-out from

card-board template and place over

lock body, making sure template is

square to door edge.

• While holding template firmly in

position, mark remaining 3 holes, as

indicated on both sides of the door

(reversing template as required).

• Drill pilot holes from both sides of the

door [suggested size 3mm (1/8")] then

enlarge, again from both sides of the

door, to sizes indicated on template,

otherwise correct functioning may be

impeded – refer template.

Step 7

• Install 2 posts to Trilock external faceplate

(this is the faceplate without the rectangular snib

push-button).

NOTE: These steps are applicable to leverset only.

Step 9

• Insert spring and snib rotor in the square hole

of the internal lever.

• Position snib rotor so one notch faces up and

the other notch points to the latch side.

• Mount outside furniture plate to outside of the

door, and align the two making sure the snib

rotor engages with the external lever.

• Fit mounting screws from inside and tighten

into threaded posts.

• Fit wood screws 3 off to inside furniture plate

(recommend pilot drilling before fitting screws).

NOTE: Test all functions for smooth operation.

NOTE: • carefully follow these instructions when installing.

• do not overtighten screws.

• use of power driver is not recommended.

• fully remove the Trilock prior to painting the door

to avoid harming the product's finish.

Step 6

To rehand external lever & set

lever operation (if required).

• If rehanding is required remove the stop

screw from SS1 & fit to SS2, to allow Lever

to operate away from door edge

Step 8

• Mount the Inside face plate so that

mark on large gear engages with mark

on lock bodygear

NOTE: There is no need to rehand the internal lever.

Wood screws (3 off)

Note: Position Snib Rotor so one notch faces

up & the other notch points to the door edge.

Mounting screws (2 off)

SS2

SS1