Gainsborough TRILOCK G1 Series Istruzioni per l'installazione
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Per serrature Gainsborough TRILOCK G1 Series. Gainsborough TRILOCK G1 Series 2. Eclipse dummy, suits 35mm to 45mm door thickness
Anche per Gainsborough TRILOCK G1 Series: Istruzioni per l'installazione (4 pagine)
Stampa la paginaInstallation Instructions for Trilock Eclipse Dummy
Step 1
• Fold template where indicated.
• Position template on door edge at
desired height, align with operating
Eclipse on opposite door.
• Firmly hold template and mark 4 off
10mm holes centres & 1 off 54mm
hole centre.
Note: it is important to drill these
holes squarely.
• Drill pilot holes [suggested size
3mm (1/8")]. Then enlarge holes as
per template, drilling from both sides
of the door.
Step 3
To rehand external lever & set lever
operation (if required).
• To rehand, remove the stop screw
and rotate the lever 180˚ and refit
the stop screw.
NOTE: • carefully follow these instructions when installing.
• do not overtighten screws.
• use of power driver is not recommended.
• fully remove the Trilock prior to painting the door
to avoid harming the product's finish.
PAIT 171
NOV '12
Suits 35mm to 45mm door thickness
Please note: Ensure the template
position and orientation is as shown,
incorrect installation voids warranty.
Stop
Screw
Step 2
• Install 4 off M4 threaded posts to
Eclipse external faceplate
Step 4
• Fit 4 off mounting screws from inside
into threaded posts.
• Align both face plates to door edge
& each other and tighten screws.
Patent Pending