Gainsborough TRILOCK G1 Series 설치 지침

{카테고리_이름} Gainsborough TRILOCK G1 Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Gainsborough TRILOCK G1 Series 2 페이지. Eclipse dummy, suits 35mm to 45mm door thickness
Gainsborough TRILOCK G1 Series에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)

페이지 인쇄

Installation Instructions for Trilock Eclipse Dummy

Step 1

• Fold template where indicated.

• Position template on door edge at

desired height, align with operating

Eclipse on opposite door.

• Firmly hold template and mark 4 off

10mm holes centres & 1 off 54mm

hole centre.

Note: it is important to drill these

holes squarely.

• Drill pilot holes [suggested size

3mm (1/8")]. Then enlarge holes as

per template, drilling from both sides

of the door.

Step 3

To rehand external lever & set lever

operation (if required).

• To rehand, remove the stop screw

and rotate the lever 180˚ and refit

the stop screw.

NOTE: • carefully follow these instructions when installing.

• do not overtighten screws.

• use of power driver is not recommended.

• fully remove the Trilock prior to painting the door

to avoid harming the product's finish.

PAIT 171

NOV '12

Suits 35mm to 45mm door thickness

Please note: Ensure the template

position and orientation is as shown,

incorrect installation voids warranty.

Stop

Screw

Step 2

• Install 4 off M4 threaded posts to

Eclipse external faceplate

Step 4

• Fit 4 off mounting screws from inside

into threaded posts.

• Align both face plates to door edge

& each other and tighten screws.

Patent Pending