Hideaway Beds Beta Bed King Manuale di istruzioni per il montaggio - Pagina 17

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Arredamento per interni Hideaway Beds Beta Bed King. Hideaway Beds Beta Bed King 20. Wallbed frame and cabinet system

Stampa la pagina

STEP 7: Install the Bed Face Panel in Cabinet

SETTING THE LIFT MECHANISM

NOTE: The Bed Face Panel is mounted between the Lift Mechanism Torsion Arms

using the supplied bolts through the holes #1-2-3 you have drilled in the Side Rails.

Set the left and right Tension Arms as shown in Drawing 13.

Place PVC pipe over Tension Arm. While sitting on floor, place one foot against the

edge of the Side Panel to hold the Bed Cabinet from moving from the wall. Pull straight

down (no side motion) so your assistant may place the arm lock in position to hold the

Lift Mechanism in the partially open position. Repeat this procedure with the other

mechanism.

ALERT: Be sure both arm locks are secure against the hexagon nuts. Do not reach

around or behind the Tension Arms; serious injury may occur if the Tension Arm is

accidentally tripped. If possible, have assistant help in the setting of the mechanism

and the loading of the Bed Face Panel.

Install the two 5/16" x 1 1/4" Allen socket head bolts in the holes #1. The head of the

bolts should be outside the Rails. Use 5/16" x 7/8" washer and 5/16" Nylock nut on the

inside. Securely tighten.

Install two 5/16" x 1 1/4" bolts (heads outside of Rails in holes #3). Put a 5/16" x 7/8"

Flat washer and 5/16" Nylock nut on each bolt from the inside of the Side Rail. Finger

tighten only and leave body of 5/16" bolt protruding on the outside of Side Rail.

Place one 5/16" x 1 1/4" bolt, 5/16" x 7/8" Flat washer, and 5/16" Nylock nut on the

floor by the front edge of each Side Panel - these will be installed in holes #2 after the

Bed Face Panel is mounted to the Lift Mechanism.

NOTE: Keep the proper size wrenches handy to securely tighten the bolts in holes #2

and #3, which is part of the next step.

Drawing 13.

Bolt in Hole #3 Drops

into this slot when Bed

Face Panel is loaded

Tension Arm

Bolt through Hole #2 to secure

Arm Lock

Hexagon Nut (Hole "A")

Notch to rest against Allen head of

Bolt in Hole #1

17.