CELETTE CEL.11244-G-01 Manuale originale - Pagina 13

Sfoglia online o scarica il pdf Manuale originale per Sistema di saldatura CELETTE CEL.11244-G-01. CELETTE CEL.11244-G-01 20.

3.8.2 ADJUST THE PRESSURE AND EXTEND DISTANCE:

EXTEND 2MM

DIAGRAM 4

1. Stud screw extend 2.0mm from 3 support feet, as the diagram 4 on left.

2. Turn left the Spring adjustment, stud welding heat will increase, torch pressure will reduce.

3. Turn light the Spring adjustment, stud welding heat will reduce, torch pressure will increase.

4. When torch pressure is not enough, please remove back cover and spring adjustment, then replace

the pressure spring.

Stud screw clamp is the part for keep the stud screw carry welding current. So make sure the diameter

of the clamp in accord with stud screw. When the diameter of the clamp is not suitable to the stud screw,

the stud screw and clamp are easily damaged. That will cause stud welding treble. Please pay attention to

the problem.

SOCKET WRENCH FOR

ADJUST SCREW CLAMP

1. Use socket wrench to lose the clamp fixed screw.

2. Pull out screw clamp and gag lever post.

3. Insert screw clamp and gag lever post to torch head. Make sure the diameter of the clamp is correct

and the length of the gag lever post is correct.

4. Use socket wrench to locking the clamp fixed screw.

Note: When Use new screw clamp, must use pliers to clamp the groove of the screw clamp.

That can make sure the screw camp and stud screw close contact.

www.celette.com

SCREW CLAMP

GAG LEVER

POST

The groove expand in use, the stud screw will loose.

Use pliers to clamp it, when meet the problem, that can

extend using life of the screw clamp.

PRESSURE

CLAMP FIXED SCREW

SPRING

ADJUSTMENT

Page No: 13