HiFiMAN HE-6 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Cuffie HiFiMAN HE-6. HiFiMAN HE-6 8.

HiFiMAN HE-6

Set-up and Operation

1. Headphone amplifiers with a minimum output power of 2 Watts into the

specified unit's impedance are recommended for best results.

2. Please allow at least 150 hours of constant use for break-in of your new

headphone. Volume does not need to be at a high level.

3. To connect your headphones to an amplifier, please use the supplied

cabling. The mini-coax plug with the red dot goes to the right side

marked with R. (Depending on the cable in use, the cable itself can also

show L and R on the plugs.) Push the connector straight onto the socket

and then use your fingers to tighten the washer. When tightening, please

make sure to move the washer only and not the cable as such. A loose

connection can lead to drop outs and distortion. Repeat the process with

the other mini-coax connector.

4. The supplied cable adaptor with the large 1/4" (6.35mm) jack is connected

with the typical headphone output of an amplifier or even better with a

headphone amplifier. Please be aware that many home amplifiers will

switch off the loudspeaker output when a headphone is connected. OFC

cable with 4-pin XLR is exclusively for use with headphone amplifiers

supporting a 4 pin XLR output.

5. To clean your headphone, please use a soft slightly damp cloth only. Do

not use any detergents and make sure not to let any fluid enter the open

sides of the headphone. The leather headband can be maintained using

standard leather care products. When your earpads become worn and

no longer offer a good connection to your head, you should replace them

with new ones which can be supplied from your dealer or from www.

head-direct.com. The internal drivers do not require maintenance. Any

attempt to remove them will void your warranty.

Owner's Guide