HiFiMAN HE-6 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Słuchawki HiFiMAN HE-6. HiFiMAN HE-6 8 stron.
HiFiMAN HE-6
Set-up and Operation
1. Headphone amplifiers with a minimum output power of 2 Watts into the
specified unit's impedance are recommended for best results.
2. Please allow at least 150 hours of constant use for break-in of your new
headphone. Volume does not need to be at a high level.
3. To connect your headphones to an amplifier, please use the supplied
cabling. The mini-coax plug with the red dot goes to the right side
marked with R. (Depending on the cable in use, the cable itself can also
show L and R on the plugs.) Push the connector straight onto the socket
and then use your fingers to tighten the washer. When tightening, please
make sure to move the washer only and not the cable as such. A loose
connection can lead to drop outs and distortion. Repeat the process with
the other mini-coax connector.
4. The supplied cable adaptor with the large 1/4" (6.35mm) jack is connected
with the typical headphone output of an amplifier or even better with a
headphone amplifier. Please be aware that many home amplifiers will
switch off the loudspeaker output when a headphone is connected. OFC
cable with 4-pin XLR is exclusively for use with headphone amplifiers
supporting a 4 pin XLR output.
5. To clean your headphone, please use a soft slightly damp cloth only. Do
not use any detergents and make sure not to let any fluid enter the open
sides of the headphone. The leather headband can be maintained using
standard leather care products. When your earpads become worn and
no longer offer a good connection to your head, you should replace them
with new ones which can be supplied from your dealer or from www.
head-direct.com. The internal drivers do not require maintenance. Any
attempt to remove them will void your warranty.
Owner's Guide
06