909 BS9 Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Sega 909 BS9. 909 BS9 16. 230mm (9") band saw

Stampa la pagina

Note.

It may be necessary to rotate the handle

anticlockwise to be able to slide the rip fence over the table

and then clockwise before locking the handle in position.

5. Attach the mitre gauge (27) onto the table by sliding it into

the mitre gauge slot.

6. Screw the push stick screw and nut into the hole at the

rear of the saw (next to the push stick storage area).

After fitting the screw, thread back the nut and tighten

against the saw housing to lock.

Upper blade guide adjustment

WARNING.

Always ensure that the saw is switched

off and unplugged from the power supply before making

any adjustments.

1. The upper blade guide (16) protects against unintentional

contact with the saw blade.

2. In order for the upper blade guide to provide adequate

protection against contact with the band saw blade (22),

it must always be set as close as possible against the

workpiece (maximum distance 3mm).

3. To adjust the height of the

upper blade guide, first

release the blade guide

height adjustment lock (18)

by turning approx. 1 turn in an

anti-clockwise direction, and

then rotate the blade guide

height adjustment knob (17).

Rotate in a clockwise direction

to move the blade guide up; rotate in an anti-clockwise

direction to move the blade guide down. After adjustment,

rotate the locking knob (18) in a clockwise direction.

4. The upper blade guide consists of a thrust bearing that

supports the band saw blade from the rear and two

guide pins that provide lateral support, these need to be

readjusted after every band saw blade change or tracking

adjustment.

Thrust bearing adjustment

1. To adjust the thrust bearing

loosen the thrust bearing

locking screw using the 3mm

hex key (32) supplied.

2. Adjust the thrust bearing

position until it is 0.5mm

away from the band saw

blade. When the band saw

blade is turned by hand it

should not make contact with the thrust bearing.

3. Tighten the thrust bearing locking screw.