909 TBD15009 Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Sander 909 TBD15009. 909 TBD15009 14. 1/2 hp benchtop belt/disc sander

Installing table assembly

1. Position table support against

table (4) and align the holes.

2. Position the table support in

the corresponding holes on the

side of the base. Ensure that

the 9.5 mm diameter index pin

aligns with the upper hole.

3. Place the 6.5 mm washer on

the end of the table lock knob

threaded shaft and insert shaft

through the slot and into the

threaded hole of base.

WARNING:

To avoid trapping the

work of fingers between the table

and sanding surface, the table

edge should be a maximum of

1-2 mm from sanding surface.

4. Loosen the 3 hex head screws

at bottom of table support

and adjust table as required.

Adjust table as necessary and

retighten screws.

1. Remove work support (9) lock

and bolt (10), and remove

work support.

2. Remove table assembly

by removing table lock knob

and washer.

3. Loosen the belt bed locking

screw (15) and raise the belt

sander bed (12) to the vertical

position. Retighten the locking screw (15).

4. Attach work table assembly (4) to auxiliary holes in belt

bed. Make sure index pin is in the upper hole when

sanding table is in vertical position.