909 TBD15009 Manuale di istruzioni - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni per Sander 909 TBD15009. 909 TBD15009 14. 1/2 hp benchtop belt/disc sander

To remove the belt

1. Use a screwdriver (not included) to undo the dust cover

screws on both sides of the belt carriage. Slide the belt

cover backwards to release it.

2. Pull the belt tension lever back.

3. Slide the belt from the rollers.

4. Replace new belt on to rollers

5. Slide belt cover over the screws and retighten the screws

6. Push belt tension lever back

1. Connect the plug to the power supply

2. To turn on press the green 'ON' button.

3. To switch off, press the red 'OFF' button.

4. Unplug the tool from the power point to prevent

unauthorised use.

Bevel sanding

1. The work table (4) can be

tilted from 0° to 45° for bevel

sanding.

2. Loosen the table lock knob

(16) and tilt the work table to

the desired angle.

3. Retighten the table lock knob.

WARNING:

To avoid trapping

the work or fingers between the

table and sanding surface, the

table should be repositioned

on the table support to retain a

maximum of 1-2 mm distance

between sanding surface and

table.