activTek OzoneBlaster Manuale - Pagina 8

Sfoglia online o scarica il pdf Manuale per Pulitore d'aria activTek OzoneBlaster. activTek OzoneBlaster 12. Electronic air purification system

SETTING/ADJUSTING (CONTINUED)

4. TREATING AN AREA

4a. SITE PREPARATION

•

Remove the contaminant or debris that may be associated with the source of the problem .

•

Clean excess contaminate residue off surfaces .

•

Seal the environment intended to be treated . Close vents and air returns . It may be

necessary to seal off return vents to prevent leakage of ozone into other areas . It may

also be necessary to seal and tape doorways and/or windows to contain the ozone and

maximize effectiveness .

4b. SIGNAGE

•

Place signage at all points of access to the treated area, during ozone decontamination and

for a minimum of 30 minutes after ozone exposure . Signage should state:

MAINTENANCE

Periodic maintenance is required to ensure that the Ozone Blaster

operates properly . A severely polluted environment can foul an

ozone plate in as little as two weeks or as long as a year . Shown

here are basic maintenance procedures that should be carried out

to keep your unit running at top performance .

Rear lint screen filter cleaning:

You have two options to clean the lint screen:

•

When visibly dirty, simply remove the lint screen and with a

hand-held vacuum remove the heavy particulate from the

screen . This method will extend the life of the filter .

- OR -

•

When visibly dirty, remove the lint screen from the back

of the unit and wash in hot water, brushing gently with a

toothbrush to remove particulate . Allow to dry prior to re-

installing the lint screen .

"DO NOT ENTER, OZONE TREATMENT IN PROGRESS."