Galvo Shed GVO 2315 Manuale di istruzioni per il montaggio - Pagina 3
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto Galvo Shed GVO 2315. Galvo Shed GVO 2315 8. Sloping roof shed
Stampa la pagina
STEP 1
DOOR ASSEMBLY
Attach the 780mm 'U' channels
at the centre ribs only. Attach the 1920mm 'U' channels
A
through the top and bottom channels
in the centre of the door sheet, slipping it under the two side 'U' channels and fixing it
to the sheet ribs and the side 'U' channels. Attach the hinges
the top and bottom of the door through the 'U' channels. The fixings should be centred
on the side 'U' channels.
Turn the door over and fix the four corners through all the 'U' channels (step 2 below).
Fit the door bracing from the bottom corner to the opposite centre to the top corner
(see step 7 on page 6).
150MM
STEP 2
HANGING THE DOOR
Attach the first 'Z' door jamb
pan. Attach the other 'Z' door jamb to the 740mm sheet
face down on the 740mm sheet
from the top. Check the door is centralised on the sheet (top and bottom). Fix the
hinges through the side of the 'Z' door jamb
the 'Z' door jamb.
4MM
GAP
If you choose to vary from these instructions your warranty will be impaired
to the top and bottom of the door sheet
J
at the four corners. Attach the door plate
J
HINGES
The hinges should protrude
over the top of the channel
N
to the 740mm sheet
L
approx 30mm up from the bottom and down
B
, raising the door about 4mm off
L
NARROW PAN
30MM
to the door sheet
H
approx 150mm from
N
H
J
on the rib with the narrow
B
. Lay the premade door
B
YOU WILL NEED
1 x 1920 x 780mm door sheet
A
H
2 x 1920mm 'U' channels
A
J
2 x 780mm 'U' channels
M
M
1 x 310mm door plate
Hinges
N
Door bracing
O
M
A
H
YOU WILL NEED
B
2 x 1980 x 740mm sheets
L
2 x 1980mm 'Z' door jambs
B
L
J
3