Galvo Shed GVO 2315 Manuale di istruzioni per il montaggio - Pagina 4
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto Galvo Shed GVO 2315. Galvo Shed GVO 2315 8. Sloping roof shed
Stampa la pagina
STEP 3
FRONT WALL
Lay down the door with the sheet attached and the 740mm sheet
sheets with the 2255mm channels
Use the door spacers
to make sure the door fits the gap (they sit on top of the
I
'Z' door jambs
). Drill and fix (rivet or screw) the channels at every second rib
L
down through the top. Attach the door spacers at each end through the 'Z' door
jambs and channels.
Put three fixings underneath through the channels into the sheeting pan and the top
and bottom of the door spacers and 'Z' door jambs (see diagram 1). Fit the padbolt to
the door strap on the outside of the door.
PADLOCK KEEPER
ASSEMBLY
KEEPER
WASHER
RIVET
ADDITIONAL
INFORMATION
4
.
F
I
F
CHANNELS
The higher side of the channel goes to the
inside of the shed. It is very important to
include the fixings on the underside of all
the channels as they are structural (except
roof channels).
. Cap the
B
L
N
CHANNEL
Fix through the top and bottom of the channels into the door
jamb and spacer. The door jamb goes on inside of the channel.
OUTSIDE
If you choose to vary from these instructions your warranty will be impaired
YOU WILL NEED
F
2 x 2255mm 'U' channels
I
2 x 793mm 'U' channels (door spacers)
B
2 x 1980 x 740mm sheets
L
2 x 'Z' door jambs (attached to B)
N
Padbolt
F
I
B
of the ends of the sheeting by
SPACER
GALVO TIP
To hinge the door on the opposite
side, simply put the top channel
on the bottom and the bottom on
the top.
Put the padbolt on the door
before erecting the panels. It will
stop the door swinging around!
INSIDE
Channels will come short
10-15mm on all panels.