Gama Garden GT-35 Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Tiller Gama Garden GT-35. Gama Garden GT-35 14. Petrol powered cultivator

Stampa la pagina

By means of a 13 mm key, screw down and remove the

six М8х12 bolts from the left and right side of the

reducer (see: Figure 3).

Place the plough iron bracket on the reducer, while

placing the right section of the bracket between the

reducer and the shield lug and the left section between

the reducer and the guard clamp (see: Figure 4, 5).

Blade

bracket

4. Fit the plough iron bracket holes and the reducer holes

(from which bolts have been removed as per Point 2)

together, then screw in the six М8х12 bolts with washer by

hand. Screw the central bolt in the reducer (from the right),

installing it in the hole of the shield lug (see: Figure 4)

Guard

clamp

Note: USE ONLY М8Х12 BOLTS.

Warning!

Do not tighten the six М8х12 bolts when performing Point 4.

By means of a 13-mm key, holding the head of the bolts,

screw off the M8 nuts with bolts of 13mm and remove

the М8х90 bolts from the handlebar bracket.

Insert the handlebar bracket in the plough iron bracket,

and place the bolts removed as per Point 5 in the

relevant holes of the brackets from outside.

Using 13-mm keys, tighten all the bolts installed as per

the previous point, starting with those fastening the

plough iron bracket to the reducer.

М8х12 screw

Figure

Shield lug

Figure

Plough

iron

bracket

Figure

2. Setting the plough iron in operating

position

Tilling depth is defined by the position of the plough iron as

compared to the bracket. There are wheels mounted on the

plough iron for the transportation of the cultivator.

For performing the tillage, set the plough iron with wheel up.

Setting the blade:

Depth of soil tilling is defined by the plough iron (tilling depth

limiter), which can be found in the lower part of the cultivator,

under the handlebar. There are wheels mounted on the

plough iron for the transportation of the cultivator. For soil

tilling, set the plough iron with wheel up (see: Figure 6).

Plough iron set

properly

Pull out the cotter pin (Point 1), remove the retaining pin

(Point 2), then remove the plough iron with wheels (Item

3) from the jointing bracket.

Place the plough iron in the bracket in such a way that

wheels stand upwards (Item 4).

Fit the hole of the bracket together with one hole of the

plough iron (Point 5), fasten it with bolt pin (Item 6) and

cotter pin (Item 7).

For increasing tilling depth, increase the length of plough iron

lower part.

Note: For efficient work performance, make sure that

plough iron is set properly as compared to the jointing

bracket (see: addition to Figure 6).

Assembly and installation of blades

Install the blades on the blade holder (Figure 7) using

М8х25 bolts, 8 washer and М8 nut (Figure 8). This

component is installed on the left side in the direction of

travel. When installing the component, make sure that

cutting edge of blades are set in accordance with the

cultivator's direction of travel. If the component is properly

assembled, then the curve of the blade nearer to the reducer

will show from the reducer to the driver.

The right side element must be assembled in the same way,

in opposite-hand view.

Figure

Figur

e 7