Game ready ATX Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Accessori per videogiochi Game ready ATX. Game ready ATX 6. Full leg boot for use with grpro 2.1 system and med4 elite system

Stampa la pagina

PRE-COOLING/PRE-HEATING YOUR WRAP

The Full Leg Boot is designed to deliver therapy over the entire leg and

foot (except the toes). During a therapy, a large amount of water is being

circulated through the Wrap. Pre-cooling/Pre-heating your Wrap will help to

deliver the best therapy possible. From time to time, you may see the actual

temperature deviate from the target temperature. This is normal.

PRE-COOLING YOUR WRAP WITH GRPRO 2.1

1. First, prime your Full Leg Boot. See Priming the Wrap.

PRE-COOLING YOUR WRAP WITH MED4 ELITE

1. Run a Cold Therapy with no compression for 2 to 3 minutes.

2. Once the actual reservoir temperature is within 2 - 3 °F (1 - 2 °C) of the

target temperature, the Wrap can be applied.

3. Stop the current therapy. Apply the Wrap.

4. Run a therapy as desired. Refer to the User Manual of your Control Unit.

PRE-HEATING YOUR WRAP WITH MED4 ELITE

1. Run a Heat therapy with No Compression for 2 to 3 minutes.

2. Once the actual reservoir temperature is within 2 - 3 °F (1 - 2 °C) of the

target temperature, the Wrap can be applied.

3. Stop the current therapy. Apply the Wrap.

4. Run a therapy as desired. Refer to the User Manual of your Control Unit.

NOTE: Never exceed the upper and lower markers when adjusting

the boot. The top edge should always be between the shortest and

longest in-seam markers.

2 of 6

2. With water in the Wrap, and

the water level of your Control Unit

at full, run a Cold Therapy with no

compression for 5 minutes.

This will allow the temperature of the

water in the Wrap to equalize with that

of the water in the GRPro 2.1 reservoir.

Run a therapy as desired. Refer to the

User Manual of your Control Unit.

ADJUSTING THE IN-SEAM LENGTH

The Full Leg Boot is designed to accommodate various in-seam lengths.

The Wrap comes ready to use with the standard length. If needed, you

may adjust the length to be either longer or shorter by following the steps

below.

TO LENGTHEN THE WRAP (LONGER IN-SEAM)

1. Detach the hook & loop of the boot section of the Wrap

so that the entire Wrap lays flat on the floor or table

2. Fold the boot section over so that the top edge aligns

with the lower marker (see icon at left). This will add

approximately 1" to the standard in-seam length.

Align top edge of boot

3. Secure the boot in place by folding the top piece of

to this line to lengthen

the in-seam length.

hook & loop toward you as shown.

TO SHORTEN THE WRAP (SHORTER IN-SEAM)

1. Detach the hook & loop of the boot section of the Wrap

so that the entire Wrap lays flat on the floor or table.

2. Fold the boot section over so that the top edge aligns

with the upper marker (see icon at left). This will subtract

Align top edge of boot

approximately 1" from the standard in-seam length.

to this line to shorten

the in-seam length.

3. Secure the boot in place by folding the top piece of

hook & loop toward you as shown.

The standard size

is shown in this

example.

Shortest

In-Seam

Fold flap

over to

secure

boot in

place

Longest

In-Seam