Bristan H64WMT2 Istruzioni per l'installazione e manuale d'uso - Pagina 10
Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso per Prodotto idraulico Bristan H64WMT2. Bristan H64WMT2 20. Single sequential d08 tmv3 thermostatic mixer taps
Stampa la pagina
Installation - Wall Mounted
1. Prepare Water Supply Pipes
Terminate suitable pipework inside
the wall cavity / stud partition,
ensuring the centres of the hot and
cold water supply pipes are 150-
200mm apart.
Important: Before drilling into
walls, check that there are no
hidden electrical wires, cables or
water supply pipes. This can be
checked with the aid of an electrical
detector.
If power tools are used do not forget
to:
•
Wear eye protection
•
Unplug equipment after use
2. Fit Mixer Tap
Position the mixer tap into the holes
in the wall surface. Tighten the
backnuts fully using a suitable
spanner.
3. Connect Pipework
Push the nuts and olives onto the
pipework. Push the pipework into the
connections ensuring the olives are
against the connections and tighten
the compression nuts to create a
water tight seal.
4. Tighten Mixer Connections
Using a suitable hexagonal key
tighten the top and bottom grub
screws on to the connections.
Note: The top and bottom grub
screws must be tightened equally.
You can now refer to the TMV
Manual to Commission the valve.
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
10
Important: Water supplies to the
mixer must be with hot on the left
and cold on the right when viewed
from the front.