Bristan H64WMT2 설치 지침 및 사용자 설명서 - 페이지 10

{카테고리_이름} Bristan H64WMT2에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan H64WMT2 20 페이지. Single sequential d08 tmv3 thermostatic mixer taps

Installation - Wall Mounted

1. Prepare Water Supply Pipes

Terminate suitable pipework inside

the wall cavity / stud partition,

ensuring the centres of the hot and

cold water supply pipes are 150-

200mm apart.

Important: Before drilling into

walls, check that there are no

hidden electrical wires, cables or

water supply pipes. This can be

checked with the aid of an electrical

detector.

If power tools are used do not forget

to:

•

Wear eye protection

•

Unplug equipment after use

2. Fit Mixer Tap

Position the mixer tap into the holes

in the wall surface. Tighten the

backnuts fully using a suitable

spanner.

3. Connect Pipework

Push the nuts and olives onto the

pipework. Push the pipework into the

connections ensuring the olives are

against the connections and tighten

the compression nuts to create a

water tight seal.

4. Tighten Mixer Connections

Using a suitable hexagonal key

tighten the top and bottom grub

screws on to the connections.

Note: The top and bottom grub

screws must be tightened equally.

You can now refer to the TMV

Manual to Commission the valve.

Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.

Important: Water supplies to the

mixer must be with hot on the left

and cold on the right when viewed

from the front.