Bristan Jute JU BASNW C Istruzioni per il montaggio ed elenco dei contenuti - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per il montaggio ed elenco dei contenuti per Prodotto idraulico Bristan Jute JU BASNW C. Bristan Jute JU BASNW C 2. Basin mixer (without waste)

Stampa la pagina
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for optimum use,
both the hot and cold supplies should be reasonably balanced.
If the fitting is installed at low pressure (tank fed), then the minimum distance from
the outlet of the nozzle to the underside of the cold tank should be approximately 2
metres to ensure adequate performance.
This mixer should be installed in compliance with Water Regulations. Where the
supplies are unbalanced, i.e. hot water from the cylinder tank / cold from the mains,
approved check valves must be fitted in the supply pipes.
For further details contact your Local Water Authority.
CONTENTS
1. Mixer Body
(x1)
2. Rubber O-Ring
(x1)
3. Rubber C-Plate
(x1)
4. Metal C-Plate
(x1)
5. Copper Tail Pipes
(x2)
6. Threaded Rod
(x2)
7. Nut
(x2)
a. Cartridge
(x1)
b. Lock Nut
(x1)
c. Shroud
(x1)
d. Handle
(x1)
e. Grub Screw
(x1)
e
d
c
b
a
1
2
3
4
5
6
7
INSTALLATION
1. Identify all components and check for completeness, particularly before arranging
fitting.
2. Install the mixer (1) into the basin. The nut (7) is used to secure the mixer to the
surface of basin using the threaded rod (6).
3. Connect the hot and cold water supplies.
4. Turn on the water supplies. Lift and turn handle both ways for a few minutes
letting the water flow , to check all joints and connections for leaks.
5. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1. Turn off the water supply.
2. Remove grub screw (e) and then remove handle (d) by pulling from cartridge (a).
Unscrew both shroud (c) and lock nut (b).
3. Using a suitable spanner, remove cartridge. Once removed, carefully clean
seating and exposed parts.
4. Replace all of the above then turn on the water supply.
5. If problem persists contact our helpline quoting the product code.
Please Note:
In the unlikely event you find a part missing please contact our Customer Service
Help line on 0870 4425553 or email [email protected] for immediate despatch
of part.