Bristan Jute JU BASNW C 피팅 지침 및 내용물 목록 - 페이지 2

{카테고리_이름} Bristan Jute JU BASNW C에 대한 피팅 지침 및 내용물 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Jute JU BASNW C 2 페이지. Basin mixer (without waste)

페이지 인쇄

WATER PRESSURE

This mixer is suitable for use at all supply pressures. However for optimum use,

both the hot and cold supplies should be reasonably balanced.

If the fitting is installed at low pressure (tank fed), then the minimum distance from

the outlet of the nozzle to the underside of the cold tank should be approximately 2

metres to ensure adequate performance.

This mixer should be installed in compliance with Water Regulations. Where the

supplies are unbalanced, i.e. hot water from the cylinder tank / cold from the mains,

approved check valves must be fitted in the supply pipes.

For further details contact your Local Water Authority.

CONTENTS

1. Mixer Body

(x1)

2. Rubber O-Ring

(x1)

3. Rubber C-Plate

(x1)

4. Metal C-Plate

(x1)

5. Copper Tail Pipes

(x2)

6. Threaded Rod

(x2)

7. Nut

(x2)

a. Cartridge

(x1)

b. Lock Nut

(x1)

c. Shroud

(x1)

d. Handle

(x1)

e. Grub Screw

(x1)

INSTALLATION

1. Identify all components and check for completeness, particularly before arranging

fitting.

2. Install the mixer (1) into the basin. The nut (7) is used to secure the mixer to the

surface of basin using the threaded rod (6).

3. Connect the hot and cold water supplies.

4. Turn on the water supplies. Lift and turn handle both ways for a few minutes

letting the water flow , to check all joints and connections for leaks.

5. See over the page for aftercare instructions.

MAINTENANCE

If the fitting begins to drip:

1. Turn off the water supply.

2. Remove grub screw (e) and then remove handle (d) by pulling from cartridge (a).

Unscrew both shroud (c) and lock nut (b).

3. Using a suitable spanner, remove cartridge. Once removed, carefully clean

seating and exposed parts.

4. Replace all of the above then turn on the water supply.

5. If problem persists contact our helpline quoting the product code.

Please Note:

In the unlikely event you find a part missing please contact our Customer Service

Help line on 0870 4425553 or email [email protected] for immediate despatch

of part.