Gamma Progression 602 FC Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Macchine incordatrici Gamma Progression 602 FC. Gamma Progression 602 FC 16.
Anche per Gamma Progression 602 FC: Manuale d'uso (16 pagine)

Stampa la pagina

Your GAMMA 600FC stringing machine is adjusted for optimum performance at the factory and needs no further

adjustments before use. After extensive use however, the machine may need minor adjusments as follows :

grip properly.

Note: The string clamps supplied with your stringing machine can accomodate tight string patterns such as

badminton. Depending on the string pattern, the clamp may spread the strings slightly which will not compromise the

quality of the string job.

MAINTENANCE

Adjusting the Turntable Bushings

There are two adjustment points on the machine base.

One is located beneath the polystyrene base cover while

the other is accessed from below the machine.

Using the supplied 3mm hex wrench, tighten both set

screws slightly until the turntable rotates smoothly with-

out excessive free play.

Repeat procedure until final adjustment is reached.

Adjusting the Clamp Pressure

The clamps provided with your stringing machine will

need minor adjustments according to what string type,

construction, and gauge you are using.

To adjust the gap (clamping pressure) between the

clamp jaws, insert the string through the racquet as if you

were beginning the main strings. Clamp the strings and

pull tension. If the string slips through the jaws of the

clamp, tighten the clamp by compressing the clamp

jaws together by hand while turning the Adjustment

Knob, in the clockwise direction. If the clamp leaves

impressions or damages the string, it may be exces-

sively tight and should be adjusted by turning the hex

screw counter clockwise to open the gap between the

jaws. The clamp jaws should be cleaned periodically to

be free from dirt, oil, and any string coating for them to