Gamma X-6 Manuale d'uso - Pagina 13
Sfoglia online o scarica il pdf Manuale d'uso per Macchine incordatrici Gamma X-6. Gamma X-6 16.
Anche per Gamma X-6: Manuale d'uso (15 pagine)
MAINTENANCE & ADJUSTMENTS
The clamp jaws must be clean and free from dirt, oil, and any string coating for them to grip
properly. Clean the clamp jaws with alcohol.
Note: The string clamps supplied with your stringing machine can accommodate tight string
patterns such as badminton. Depending on the string pattern, the clamp will spread the strings
slightly which will not compromise the quality of the string job.
TROUBLESHOOTING TIPS
PROBLEM
String slips in clamps
String slips in gripper
Turntable Bushing Adjustment
The turntable bushing is adjusted at the fac-
tory for optimum performance. After time and
use, the turntable bushings may need minor
adjustment. An adjustment is indicated when
noticeable turntable looseness or wobble
occurs while stringing.
To adjust the fi t between the turntable pin
and the bushings, tighten the set screw at the
top of the bushing using a 3mm hex wrench.
Tighten until the turntable rotates smoothly
without excessive free play.
Adjusting the Clamps
The clamps provided with your stringing
machine will need minor adjustments accord-
ing to string type, construction, and gauge.
To adjust, route the string through the racquet
as if you were beginning the main strings.
Adjustment
Clamp the strings and pull tension. If the
Knob
string slips through the jaws of the clamp,
tighten the clamp by turning the adjustment
knob opposite of the handle, in the clockwise
direction. If the clamp leaves impressions or
damages the string, it is too tight and must
be adjusted by turning the adjustment knob
counterclockwise.
- Adjust gap between clamp jaws
- Clean clamp jaws
- Clean gripper jaws
- Make sure string is wrapped over top gripper
prior to inserting between gripper jaws
13
SOLUTION