Gamma X-6 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Gamma X-6에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-6 16 페이지.
Gamma X-6에 대해서도 마찬가지입니다: 소유자 매뉴얼 (15 페이지)

MAINTENANCE & ADJUSTMENTS

The clamp jaws must be clean and free from dirt, oil, and any string coating for them to grip

properly. Clean the clamp jaws with alcohol.

Note: The string clamps supplied with your stringing machine can accommodate tight string

patterns such as badminton. Depending on the string pattern, the clamp will spread the strings

slightly which will not compromise the quality of the string job.

PROBLEM

String slips in clamps

String slips in gripper

Turntable Bushing Adjustment

The turntable bushing is adjusted at the fac-

tory for optimum performance. After time and

use, the turntable bushings may need minor

adjustment. An adjustment is indicated when

noticeable turntable looseness or wobble

occurs while stringing.

To adjust the ﬁ t between the turntable pin

and the bushings, tighten the set screw at the

top of the bushing using a 3mm hex wrench.

Tighten until the turntable rotates smoothly

without excessive free play.

Adjusting the Clamps

The clamps provided with your stringing

machine will need minor adjustments accord-

ing to string type, construction, and gauge.

To adjust, route the string through the racquet

as if you were beginning the main strings.

Adjustment

Clamp the strings and pull tension. If the

Knob

string slips through the jaws of the clamp,

tighten the clamp by turning the adjustment

knob opposite of the handle, in the clockwise

direction. If the clamp leaves impressions or

damages the string, it is too tight and must

be adjusted by turning the adjustment knob

counterclockwise.

- Adjust gap between clamp jaws

- Clean clamp jaws

- Clean gripper jaws

- Make sure string is wrapped over top gripper

prior to inserting between gripper jaws

SOLUTION