Gamma X-6 소유자 매뉴얼 - 페이지 4
{카테고리_이름} Gamma X-6에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-6 16 페이지.
Gamma X-6에 대해서도 마찬가지입니다: 소유자 매뉴얼 (15 페이지)
ASSEMBLY INSTRUCTIONS
Winder Support Stand Installation
Remove the M5 bolts from the 2 brackets
located in the rear slots of the machine base
using the 5MM hex key. Slide the brackets
to the right end of the base and position the
winder stand over the brackets aligning the
holes in the base of the winder stand with the
holes in the brackets. Attach the winder sup-
port stand using the M5 bolts. Install all 4 bolts
loosely at fi rst and then tighten all securely.
Engaging the Drop Weight Bar Stop
The stringing machine is shipped with the
drop weight bar in the horizontal position. To
limit the rotation of the drop weight bar and
prevent racquet damage during stringing,
the bar stop must be engaged.
Hold the drop weight bar in the vertical posi-
tion as shown while turning the 5mm stop
screw located on the back side of the winder
stand clockwise.
Installing the Drop Weight
Remove the end cap from the tension bar and
slide the drop weight onto the bar. The weight
should be oriented with the knob end closest
to the string winder. Replace the end cap.
4