Century Helicopter Products CN1074 Manuale - Pagina 7

Sfoglia online o scarica il pdf Manuale per Giocattolo Century Helicopter Products CN1074. Century Helicopter Products CN1074 15.

Stampa la pagina

Century Helicopter Products CN1074 Manuale

STEP 4 Drilling Components

Hinges and door pivot locks must be drilled when on the sheet material. Follow the chart for hole size by part. As

these parts are small, extra pieces are provided in case of accidental damage, it is best that all components are

prepared at this time.

STEP 5 Trimming Components

After the parts are drilled, divide the sheet parts

with heavy shears and then using a straight routing

bit in a moto-tool trim each part leaving 1/32" of

material on each part. Use a flat file for the hori-

zontal fin end caps and vertical fin, use a needle

file for the small parts to shape to final size.

STEP 6 Mounting Hinges

Hinge order is important, left door top #3, bottom #1, left cabin top #4, bottom #2. Right door top #1, bottom #3,

right cabin top #2, bottom #4. Attach each door hinge using two M1.4x5 Round Head Phillips Screws and two

M1.4 Hex Nuts from the inside. Attach each cabin hinge using two M1.4x6 Flat Head Phillips Screws and two

M1.4 Hex Nuts. When mounting the hinges on the doors and the cabin the ears of the hinge point toward the

front. Also, test fit each door to its side as some slight filing of the slot in the door may be necessary for a good fit

and note that the door hinges mount on top of the cabin hinges. After each bolt is secured, apply a single drop of

locktight to each nut.

Doors are knotched to

be able to swing open.

When the door is closed

it will overlap the cabin

door opening and remain

on the outside.

M1.4x5 Round Head

Phillips Screws x 8

M1.4 Hex Nut x 8

[CN1074-8]

Door hinges have

straight holes.

Left Door

Location

Pivot lock wire holes

Pivot lock center hole

Hinge holes

Horizontal Fin (1/2 depth)

Hinge holes on doors

Hinge holes on cabin

Pivot lock hole on doors

Door handle holes on door 1.8mm [0.071"]

Vertical fin

Tail Light Mount

Tail fins,

strobe light,

hinges & acc.

[CN1074-5]

M1.4x6 Flat Head

Phillips Screws x 8

M1.4 Hex Nut x 8

[CN1074-8]

Cabin hinges have

counter sunk holes.

As in the case with the

fiberglass components,

extra hardware is

provided for conve-

nience if a fasterener is

lost or damaged.

Bell47G II Detail Manual

Drill Bit Size

Req'd

0.8mm [1/32"]

1.5mm [1/16"]

2.0mm [0.079"]

3.0mm [0.125"]

Right Cabin Door Opening