Century Helicopter Products CN1074 Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Giocattolo Century Helicopter Products CN1074. Century Helicopter Products CN1074 15.

Stampa la pagina

Century Helicopter Products CN1074 Manuale

STEP 9 Cabin & Fuel Tank Mount Hardware

The long cabin mounts will be fitted at the joint between the servo side frames and the upper side frames

where the M2x12 threaded stud is pre-installed in the kit version. Remove the original M3x6 bolt. Insert

one short all threaded rod with threadlock through the servo side frame and into the nut in the lower side

frames using threadlock, then thread the long cabin mount onto the stud using threadlock. Tighten with a

hex key inserted through the hole in the mount. Repeat for the other side. The short fuel tank mounts are

installed into the rearward hole behind the main shaft. The left mount will fit easily into the recess for

the socket head cap screw but the opposite side needs to be opened out to 6mm

using a drill bit. Only drill until the mount touches the bottom of the

recess. Insert the 3mm rod threaded on both ends through the me-

chanics, apply threadlock to both ends of the rod and attach the

upper fuel tank mounts. On the lower fuel tank mounts, the

two machined grommet fittings must be attached first,

carefully insert the fittings, being careful not to cross

thread them. Once each has started, remove it,

apply threadlock and tighten in place. It is best

to hold the narrow straight section with

pliers to tighten as not to damage the

head that will engage the grommet.

Insert one all threaded rod into the end

of the mount using threadlock. Re-

move the rearmost M3x12 Self

Tapping Screws from the bottom

starting block and insert the fuel

tank mounts by threading in place.

The final position has the mount at a

slight downward angle to the rear.

STEP 10 Fuel Tanks

Insert three rubber grommets into each fuel tank,

be careful not to crush the hollow tanks. Lift the

edge of each grommet and insert a small amount

of "Goop" adhesive to bond them in place. Each

fuel tank is marked on the bottom for the left and

right sides. To mount the fuel tanks, hold the tank

at a horizontal position and "roll" onto the lower

mounts and then press into the upper mount.

Rubber Grommets x 6

[CN1074-7]

Drill the two holes on the plastic hook to 3mm.

Attach two 27mm spacers between the battery

tray and the plastic hook using four M3x12

Fuel Tanks x 2

[CN1074-4]

Cabin

Spacers x 2

[CN1074-6]

Bell47G II Detail Manual

Fuel Tank Mounts

Long Cabin Mount

[CN1074-6]

STEP 11 Cabin Mount

Socket Cap Screws using threadlock.

M3x12 Socket

Cap Screws x 4

[CN1074-6]