IKEA Lagan HGA4K Manuale d'uso - Pagina 22

Sfoglia online o scarica il pdf Manuale d'uso per Piano cottura IKEA Lagan HGA4K. IKEA Lagan HGA4K 28. Ikea hobs instruction manual
Anche per IKEA Lagan HGA4K: Manuale d'uso (16 pagine), Manuale di istruzioni (24 pagine), Manuale di istruzioni (20 pagine), Manuale di istruzioni (24 pagine), Manuale di istruzioni (16 pagine)

Stampa la pagina

ENGLISH

Warning! Once the installation is

complete, check the perfect seal of every

pipe fixing. Use soapy water, never flame.

Electrical connection

Before connecting, check that the nominal volt-

age of the appliance stated on the rating

plate, corresponds to the available supply

voltage. Also, check the power rating of the

appliance and ensure that the wire is suitably

sized to suit the appliance power rating (refer

to the Technical data chapter).

The rating plate is located on the lower casing

of the hob.

The appliance is supplied with a connection

cable. This has to be provided with a proper

plug, able to support the load marked on the

identification plate. To connect the plug to the

cable, follow the recommendation given in fol-

lowing figure.

Replacement of the connection cable

The replacement of the connection cable re-

quires the specific equipment of a technician.

In this case, only cable type H05V2V2-F T90

must be used. The cable section must be suit-

able to the voltage and the working temper-

ature. The yellow/green earth wire

approximately 2 cm longer than the brown (or

black) phase wire

(previous figure).

The plug has to be fitted in a proper socket. If

connecting the appliance directly to the elec-

tric system, it is necessary that you install a

double pole switch between the appliance

and the electricity supply, with a minimum gap

of 3 mm between the switch contacts. The dou-

ble pole has to be of a type suitable for the

required load in compliance with the current

rules.

The connection cable has to be placed in order

that, in each part, it cannot reach a 90 °C tem-

perature. The blue neutral cable must be con-

nected to the terminal block marked with "N".

The brown (or black) phase cable (fitted in the

terminal block contact marked with "L") must

always be connected to the live phase.

Gas setting conversion

This model is designed for use with natu-

ral gas but can be converted for use with

butane or propane gas providing the correct

injectors. The injectors not supplied with the

appliance have to be ordered from After Sales

Service (refer to the Service chapter).

For data concerning injector replacement, see

chapter "Technical data"

Warning! Conversion or replacement

can only be performed by a registered

installer.

To replace injectors:

1. Remove pan support.

2. Remove burner cap and crown.

3. With a socket spanner 7 unscrew and re-

move the injectors, replace them with the

ones required for the type of gas in use.

4. Reassemble the parts, following the same

procedure backwards.

Important! Replace the rating label (placed

near gas supply pipe) with relevant one for the

new type of gas supply before sealing the

appliance. If the appliance is already sealed

please stick it directly on the user manual

must be

booklet after Technical data chapter close to

the rating plate drawing.

You can find this label in package sup-

plied with appliance