KitchenAid KD-20 SERIES Manuale di istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavastoviglie KitchenAid KD-20 SERIES. KitchenAid KD-20 SERIES 6. Built-in dishwasher

Stampa la pagina
0
2
CONNECTING
HOT
WATER
SUPPLY
LINE
0
3
CONNECTING
DRAIN
LINE
Make certain
fill
line has been flushed
clear of foreign
materials.
Use compression
ell
(furnished)
to connect
l/2"
O.D. copper
fill
line to dishwasher
fill valve. Make
sure fill
line
has no sharp bends (5" min. bend radius
suggested)
that
may produce
kinks which
might restrict
water
flow.
Connect
fill
line
to meet local
plumbing
codes.
Connect
dishwasher
drain
to
meet
local
plumbing
code.
See suggested
instailations
FIG.
4. See note for available
drain
acces-
sories.
0
CONNECTING
ELECTRICAL
4
POWER
SOURCE
WARNING:
BE SURE
ELECTRICAL
POWER IS TURNED
OFF AT
CIRCUIT
BREAKER.
-GROUNDING
INSTRUCTIONS
-
This
appliance
must
be connected
to a grounded
metal, permanent,
wiring
system; or an equipment-grounding
conductor
must be run with
the circuit
conductors
and connected
to the equipment-grounding
ter-
minal or lead of the appliance.
A - Remove junction
box from dishwasher,
B - Install approved con-
nector
(not furnished).
C - Connect
power cable white
lead to white
lead and black to black lead with
adequate
insulation
or wire nuts and
ground
wire
under
green ground
screw or lug. Reinstall
junction
box.
When house wiring
is aluminum,
use UL listed aluminum
to copper
connectors.
0
5
TESTING
INSTALLATION
Remove installation
debris from under dishwasher,
foam door pads on each side and near top
of tank, and all internal
packing material
and labels. NOTE: Do not remove white plastic glides
on sides of door or white plastic bumpers on front corners of lower rack.
Custom and Imperial
Models
Patrician and Superba Models
Close
door
and
latch
handle.
Turn
on
electrical
and water
supplies.
Turn
Cycle
Selection
Dial
clockwise
until
it clicks
in
"Heavy
Wash"
position.
Push
"Heavy
Wash" button
and allow
dishwasher
to run
through
the complete
cycle to make certain
it is operating
properly.
Turn off electrical
power,
remove
lower
panel and check for
leaks.
Reinstall
lower
panel
and turn
on
electrical
power.
Close door and latch handle.
Press "Cancel
Cycle"
button;
timer
will
automatically
advance to off.
Lift
door handle'and
wait
for timer to reset itself.
Latch door handle
and
press
"Heavy
Wash"
button.
Run
dishwasher
through
the complete
cycle to
make certain
it is operating
properly.
Turn
off
electrical
power,
remove
lower
panel
and check for leaks. Reinstall
lower panel
and turn on electrical
power.