KitchenAid KD-20 SERIES Manuale di istruzioni per l'installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavastoviglie KitchenAid KD-20 SERIES. KitchenAid KD-20 SERIES 6. Built-in dishwasher

Stampa la pagina
OPENING
FOR DISHWASHER
k---
24"
---/
DISHWASHER FILL LINE
rii
FIG. 3
(3)
DRAIN
SYSTEM
The dishwasher
is equipped
with
a pump type drain.
. . Except
during drain periods, drain valve is closed thus
Zrotecting
the dishwasher
from
normal
back flow
from
drain
line. Dishwasher
can be connected
to a
drain line through
the back wall to a sink or d&poser
to either right or left side or to an air gap. Note figure
4 for dimensions
for
locations
of drain
line.
Note
figure
2 for area to be kept
free of all plumbing
connections.
Connect
a g/16"
I.D. minimum
drain
line
(furnished
by installer)
to drain
valve.
When
flexible
hose is used, it must be resistant
to heat and
0
2
HOT WATER
SUPPLY
LINE
If the fill
line
comes from
either
right
or
left,
it must be installed
behind
the vertical
frame
members
which
are 2-g/16"
from
the
wall.
Locate
fill
line
according
to FIG.
3.
For roughing-in
purposes,
locate
3/4"
hole
19-l/2"
from back wall and 6 inches from left
edge of cabinet
For other
typical
fill
line
installations
such as water line from back see
alternate
(dotted line) suggestions.
All
sweat
fittings
for
l/2"
O.D.
copper
tubing
must
be sweat
into
place
before
attaching
to dishwasher
to prevent
excess
heat on fill valve. Make certain
that there is
a hand shut off valve (A or B, Fig. 3) in the
hot water supply
line.
To
conveniently
service
dishwasher,
it
is
recommended
a union be connected
in the fill
line.
detergent
water. When copper
tubing
is used, make
the connection
to drain valve using a short length of
flexible
hose and clamps.
Flexible
drain
hose and
clamps are furnished
in KD-IKA
installation
kit avail-
able from your local KitchenAid
dealer or distributor.
Drain
connections
must be in compliance
with
local
codes. Do not install check valve in drain line. When
connecting
dishwasher
drain to a food waste disposer,
be sure to remove the knockout
(or threaded)
plug in
the diposer to insure proper drainage.
NOTE: Do Not Kink Drain Hose.
Minimum
Size For AlI Dishwasher
Drains Is 9/16" I.D.
A Drain Gap May Be Required.
Consult Your Local Codes.
ING-NO1
WRNl
SINK CONNECIION