GREEN SERIES FITNESS CIR-TM7000E-G Procedura - Pagina 3

Sfoglia online o scarica il pdf Procedura per Tapis roulant GREEN SERIES FITNESS CIR-TM7000E-G. GREEN SERIES FITNESS CIR-TM7000E-G 3. Suspension upgrade procedure
Anche per GREEN SERIES FITNESS CIR-TM7000E-G: Procedura di aggiornamento (20 pagine)

Stampa la pagina

Step 4

– Take the motor hood cover off and set aside.

Step 5

– Take treadmill and tip on its side. On the underside using two 17mm wrenches take elevation bolt and nut off

elevation Motor shaft to main elevation assembly. Pull elevation assembly away from elevation motor

shaft. Take the bolt and nut and put in the small container ie. Soup Bowl.

Step 6

Note: Be extremely cautious of high voltage and moving parts at these next few steps. Then turn on the power

switch. Wait about 20 to 30 seconds for display to completely turn on.

Step 7

– With the treadmill on its side, separate elevation lower frame from elevation lower shaft, at least by 6" or

more. Turn on quick start. DO NOT SPEED UP. Elevate to 2% and elevation lower shaft should spin

clockwise for a few seconds then stop. Display screen should read 2%. Elevate back to 0% and elevation lower

shaft should spin in counter-clockwise for a few seconds and stop. Display screen should read 0%. Hit stop on

display, turn off power switch and unplug power cord from treadmill.

Step 8

- While treadmill is still on its side, line up elevation motor lower shaft with elevation frame. Insert bolt to connect

both parts. Bolt should easily go in both with less than 1/4 " (5 mm) gap between the elevation frame and dual

rubber stoppers on frame. If need be, adjust elevation shaft by turning clockwise or counter-clockwise to

specifications above, then reinsert bolt and nut.

Step 9

- Turn on quick start. DO NOT SPEED UP. Elevate to 2% and elevation assembly should move away from

treadmill frame. Display screen should read 2%. Elevate back to 0% and elevation assembly should come

back to frame almost hitting or barely hitting frame rubber stoppers. Display screen should read 0%. Hit stop

on display, turn off power switch and unplug power cord from treadmill.

Step 10

- Tighten down elevation lower shaft bolt and nut with 17mm wrenches to estimated 50lbs of torque. (100%

tighten then loosen 5 degrees turn). Turn treadmill back upright.

Step 11.

- Re-Install the 110v cord in both the treadmill and wall outlet. Then turn on the power switch. Wait about 20 to

30 seconds for display to completely turn on. Hit quick start. Turn on quick start. Confirm treadmill speed and

elevation working correctly. (Note; When elevation at 0%, lower elevation frame should be resting on rubber

stops with no gap.

Step 12

- Re-install treadmill motor hood cover. Find screws in the small container ie. Soup Bowl. First take the two

machine Phillip head screws 4mm with a #2 Phillip screw driver to rear of hood to frame. (Note: make sure front

of hood is resting on top of side rails, not jammed in front). Slide down both hood/rail covers with rubber

grommets to main hood. Install both front phillips head screws on hood to frame metal clips. Then install back

hood/rail covers to main hood. And finally, reinstall power cord sure connect with a #1 Phillips screw driver to

treadmill frame.

www.GreenSeriesFitness.com

©May 2015

Call Toll free at (800) 269-7130

CIR-TM7000E-G Revision 1.1