Bernina HLT002 Istruzioni per il montaggio - Pagina 3
Sfoglia online o scarica il pdf Istruzioni per il montaggio per Accessori per macchine da cucire Bernina HLT002. Bernina HLT002 5. Lift table extension kit
Stampa la pagina3. INSTALL SHELF
Position Shelf under Shelf Sides so
only 4 bolt holes can be seen from
bottom. Secure Shelf to Shelf Side
using 4- 1/4 20 X 2" PH bolts
with #2 Phillips Screwdriver as
shown in Figure #3. If bolt will not
thread in refer to Figure #3-B
TYPICAL CONNECTOR!
JOINT
NOTE: IF BOLT WILL NOT THREAD INTO!
BARREL NUT, TURN NUT 1/2 TURN. (180º)
4. INSTALL SWIVEL CLAMPS
Locate 4-Pre-drilled Holes under!
each Drop Leaf. Install 1-Swivel!
Clamp with 4- #6 X 1 1/8"FH!
screws using #2 Phillips Screwdriver!
as shown in Figure #4. Refer to !
Figure #4-B for detail view.
LIFT TABLE EXTENSION KIT!
ASSEMBLY INSTRUCTIONS
SHELF SIDE
FIGURE #3-B
BARREL NUT
FIGURE #4-B
SWIVEL CLAMP
VIEW OF BACK OF TABLE
VIEW OF FRONT OF TABLE
DROP LEAF
PRE-DRILLED!
HOLES
PAGE 3
7/3/2019
FIGURE #3
SHELF SIDE
1/4 20 X 2"PH!
BOLT
FIGURE #4
DROP LEAF
PRE-DRILLED!
HOLES
#6 X 1 1/8"FH SCREW