Bernina HLT002 Montage-instructies - Pagina 3

Blader online of download pdf Montage-instructies voor {categorie_naam} Bernina HLT002. Bernina HLT002 5 pagina's. Lift table extension kit

Pagina afdrukken
3. INSTALL SHELF
Position Shelf under Shelf Sides so
only 4 bolt holes can be seen from
bottom. Secure Shelf to Shelf Side
using 4- 1/4 20 X 2" PH bolts
with #2 Phillips Screwdriver as
shown in Figure #3. If bolt will not
thread in refer to Figure #3-B
TYPICAL CONNECTOR!
JOINT
NOTE: IF BOLT WILL NOT THREAD INTO!
BARREL NUT, TURN NUT 1/2 TURN. (180º)
4. INSTALL SWIVEL CLAMPS
Locate 4-Pre-drilled Holes under!
each Drop Leaf. Install 1-Swivel!
Clamp with 4- #6 X 1 1/8"FH!
screws using #2 Phillips Screwdriver!
as shown in Figure #4. Refer to !
Figure #4-B for detail view.
LIFT TABLE EXTENSION KIT!
ASSEMBLY INSTRUCTIONS
SHELF SIDE
FIGURE #3-B
BARREL NUT
FIGURE #4-B
SWIVEL CLAMP
VIEW OF BACK OF TABLE
VIEW OF FRONT OF TABLE
DROP LEAF
PRE-DRILLED!
HOLES
PAGE 3
7/3/2019
FIGURE #3
SHELF SIDE
1/4 20 X 2"PH!
BOLT
FIGURE #4
DROP LEAF
PRE-DRILLED!
HOLES
#6 X 1 1/8"FH SCREW