Avante FURMDKAVNAH12 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Arredamento per interni Avante FURMDKAVNAH12. Avante FURMDKAVNAH12 12. Motorised height adjustable desk

Stampa la pagina
Motorised Height Adjustable Desk

Operation

Control Panel

Control
Description
Display
Shows current height or other information, such as when a reset is required or when saving
a pre-set height etc.
▲
Raise desk height. Press and hold, then release when required height is reached.
▼
Lower desk height. Press and hold, then release when required height is reached.
1
Press to
2
Press to
3
Press to
M
Press to
A
Press to activate the

Functions and Using the Desk

To use the desk:
1. Connect the supplied electrical cable to the motor control module, and at the other end to a grounded
240VAC / 50Hz mains electrical supply.
2. Switch the electrical supply ON at the power outlet.
3. The control panel will illuminate – the desk is ready to use.

Resetting

Before using the desk, you must "reset" it – resetting means that the motor control module needs to "know"
when the legs are at the lowest position, as a reference.
Press and hold "▼" on the control panel – the desk will lower. Once reaching the lowest position, the motor
will stop. Continue pressing ▼. The desk will then rise approximately 5mm to an indicated height of "75.0" or
a similar number (approximately 75cm form the top of the desk to ground level). Once this occurs, release
▼. The desk can now be used.

Adjusting Height

The motor has a "duty cycle" of 2 minutes per 20 minutes. This means that the desk can be raised or
lowered continuously for approximately 2 minutes. After this time, the motor must be allowed to cool
for approximately 18 minutes before being used again to raise or lower the desk.
To raise the desk, press and hold ▲ until the desired height is reached. To lower the desk, press and hold ▼
until the desired height is reached. The actual height from the top of the desk to ground level is shown in the
display.
E&OE
go to pre-set height
"1".
go to pre-set height
"2".
go to pre-set height
"3".
save a pre-set
height.
reminder
timer.
© 2017 Avante
9