CORNING UAT3 Manuale di istruzioni per l'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Strumenti CORNING UAT3. CORNING UAT3 18.

Stampa la pagina

3.2

In addition to the UAT3 kit, fiber or ribbon splice tray(s),

and cable closure or terminal, the following tools and materials are

required:

• Utility knife *

• Scissors*

• Fiber Clean® wipes *

• Vinyl tape *

• Cable ties *

• Spatula *

• Tape measure *

• Needle-nose pliers

• Model 45-163 for 0.125 - 0.218 in tubes (p/n 100107-01)

• Model 45-164 for 0.25 - 0.56 in tubes (p/n 3204002-01)

3.3

Additional items required for grounding:

• Grounding hardware and tools approved by your company

• Pliers

* Items available in the M67-003 Fusion Splicing Tool Kit

Cable Preparation

4.1

Prepare the drop cable

according to instructions appropriate

for the cable and the closure or

terminal in which you are placing the

cables. Place the prepared drop cable

aside in a secure place.

4.2

Determine the center of the

slack loop of the cable. Measure and

mark a distance of 100 cm (40 in) on

both sides of this midpoint. Place a wrap of tape at each of these points

to mark a total of 200 cm (80 in) of cable to be accessed (Figure 3).

NOTE: More or less cable may be accessed according to slack need

and availability. This length could be 250 cm (100 in) or more.

When installing aerial terminals (such as the SCA), position the

terminal on the strand and then mark the appropriate section of

cable to be accessed.

Standard Recommended Procedure 004-074 | Issue 12 | May 2017 | Page 5 of 18

• Cotton swabs *

• Isopropyl alcohol

• Plastic bristle brush

(e.g., tooth brush)

• Permanent marking

pen *

• Ideal® buffer tube

cutters:

Tape

Figure 3