Garaventa Lift X3 Manuale di avvio rapido - Pagina 6

Sfoglia online o scarica il pdf Manuale di avvio rapido per Sedia a rotelle Garaventa Lift X3. Garaventa Lift X3 7. Incline wheelchair lifts

Stampa la pagina

3.Provide overspeed governor and brake on upper carriage drive, containing

mechanical overspeed sensor and lock, with electrical drive cut-out

protection.

4.Provide with manual handwheel for emergency operation.

5.Provide platform with folding seat.

Call Stations:

1.Provide wireless call stations at both landings.

2.Call stations shall be provided with directional control buttons for call and send.

3.A one-touch control system shall be used to automatically fold/unfold the platform,

boarding ramps and passenger safety arms.

4.Provide Attendant remote control call station.

Finish:

1.Design and fabricate lift to manufacturer's standard design for indoor and outdoor

locations.

2.Platform Cover: Provide a durable and weather resistant nylon platform cover for

protection.

PART 2 3EMERGENCY EVACUATION DEVICE

Portable evacuation chair, Garaventa "Evacu-Trac" with steel storage enclosure:

1.Capacity: 1 person, 300 lbs (136 kg) with minimum 1.5 times safety factor.

2.Maximum Stair Angle: 40 degrees.

3.Speed Governor: Piston brake.

4.Brake: Manual mechanical brake, attendant must release brake bar for descent.

5.Surface Mount Cabinet:

PART 3 EXECUTION

PART 3 1EXAMINATION

X3 Specification 23265-A-DS Section 14 42 13

Direct Mount Wood Stud Walls: Upper rail attached to a 2 inch

(51 mm) by 8 inch (203 mm) board that is secured to the wall.

Lower rail attached to a 2 inch (51 mm) by 4 inch (102 mm)

board secured to the wall. Fasten each board to every available

stud with a minimum of two fasteners.

Tower Mount Struts: Provide with 2-1/2 inches (65 mm) by 2-1/2

inches (65 mm) hollow structural steel tubular posts to support

the guide rails.

Provide a mechanical stop at the upper landing to prevent over-travel

of the drive carriage in the event of a switch failure.

Aluminum guide rails and ramps to be anodized aluminum. Steel

components shall be powder coated as follows:

Fine Textured Satin Grey (RAL 7030).

Custom color as selected by Architect from an RAL color chart.

Electrical printed circuit boards and control transformers to be treated

with a conformal coating for resistance to ambient moisture.

Steel cabinet and door panel. Available only in Satin Gray, left hinged

only.

Size: Height 45-3/8 inches (1151 mm), width 20 inches (508 mm),

depth 11 inches (279 mm).

Page 6