Garaventa Lift X3 Snelstarthandleiding - Pagina 6

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Garaventa Lift X3. Garaventa Lift X3 7 pagina's. Incline wheelchair lifts

Pagina afdrukken

3.Provide overspeed governor and brake on upper carriage drive, containing

mechanical overspeed sensor and lock, with electrical drive cut-out

protection.

4.Provide with manual handwheel for emergency operation.

5.Provide platform with folding seat.

Call Stations:

1.Provide wireless call stations at both landings.

2.Call stations shall be provided with directional control buttons for call and send.

3.A one-touch control system shall be used to automatically fold/unfold the platform,

boarding ramps and passenger safety arms.

4.Provide Attendant remote control call station.

Finish:

1.Design and fabricate lift to manufacturer's standard design for indoor and outdoor

locations.

2.Platform Cover: Provide a durable and weather resistant nylon platform cover for

protection.

PART 2 3EMERGENCY EVACUATION DEVICE

Portable evacuation chair, Garaventa "Evacu-Trac" with steel storage enclosure:

1.Capacity: 1 person, 300 lbs (136 kg) with minimum 1.5 times safety factor.

2.Maximum Stair Angle: 40 degrees.

3.Speed Governor: Piston brake.

4.Brake: Manual mechanical brake, attendant must release brake bar for descent.

5.Surface Mount Cabinet:

PART 3 EXECUTION

PART 3 1EXAMINATION

X3 Specification 23265-A-DS Section 14 42 13

Direct Mount Wood Stud Walls: Upper rail attached to a 2 inch

(51 mm) by 8 inch (203 mm) board that is secured to the wall.

Lower rail attached to a 2 inch (51 mm) by 4 inch (102 mm)

board secured to the wall. Fasten each board to every available

stud with a minimum of two fasteners.

Tower Mount Struts: Provide with 2-1/2 inches (65 mm) by 2-1/2

inches (65 mm) hollow structural steel tubular posts to support

the guide rails.

Provide a mechanical stop at the upper landing to prevent over-travel

of the drive carriage in the event of a switch failure.

Aluminum guide rails and ramps to be anodized aluminum. Steel

components shall be powder coated as follows:

Fine Textured Satin Grey (RAL 7030).

Custom color as selected by Architect from an RAL color chart.

Electrical printed circuit boards and control transformers to be treated

with a conformal coating for resistance to ambient moisture.

Steel cabinet and door panel. Available only in Satin Gray, left hinged

only.

Size: Height 45-3/8 inches (1151 mm), width 20 inches (508 mm),

depth 11 inches (279 mm).

Page 6