Makita BJV180 Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita BJV180. Makita BJV180 13. Cordless jig saw
Anche per Makita BJV180: Ripartizione delle parti (3 pagine), Scheda tecnica (2 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine), Informazioni tecniche (13 pagine), Manuale di istruzioni (18 pagine)

Stampa la pagina
Makita BJV180 Manuale di istruzioni
1
007499
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
•
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting radius,
•
and tighten the bolt to secure it in place. Then
move the base all the way forward.
NOTE:
Always use blades No. B-17, B-18, B-26 or B-27
•
when cutting circles or arcs.
Guide rail adapter set (accessory)
007500
When cutting parallel and uniform width or cutting
straight, the use of the guide rail and the guide rail
adapter will assure the production of fast and clean cuts.
To install the guide rail adapter, insert the rule bar into
the square hole of the base as far as it goes. Secure the
bolt with the hex wrench securely.
1
007501
Install the guide rail adapter on the rail of the guide rail.
1. Fence guide
2. Threaded knob
3. Circular guide
pin
2
3
1. Bolt
2. Rule bar
2
Insert the rule bar into the square hole of the guide rail
adapter. Put the base to the side of the guide rail, and
secure the bolt securely.
3
007502
CAUTION:
Always use blades No. B-8, B-13, B-16, B-17 or 58
•
when using the guide rail and the guide rail
adapter.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
007505
10
1. Guide rail
adapter
2. Screw
1
3. Guide rail
2
1. Limit mark
1
1. Brush holder
cap
2. Screwdriver
2